Deploy Or Stow The Ulterra Trolling Motor; Deploy The Motor; Stow The Motor; Pause Deploying Or Stowing - Humminbird i-PILOT LINK Operation Manual

D S
EPLOY OR TOW THE
If you have an Ulterra trolling motor installed, you can deploy or stow the motor using the X-Press Remote on the HELIX control head.
See your i-Pilot Link Owner's Manual for details.
WARNING! Before you deploy or stow the motor, confirm the motor is clear from obstructions and has a clear path of travel. The
propeller is disabled while the motor is being trimmed to prevent accidental contact with the rotating propeller.

Deploy the Motor

The first time you deploy the motor (after installation or after defaults have been reset), you will adjust the trim for operation. The
control head will save the most-recent trim setting and apply it when the motor is deployed again.
WARNING! As soon as Deploy Ulterra is selected, the motor will deploy automatically. Before you deploy or stow the motor,
confirm the motor is clear from obstructions and has a clear path of travel. The propeller is disabled while the motor is being
trimmed to prevent accidental contact with the rotating propeller.
1. Press the POWER key.
2. Select Deploy Ulterra. Press the RIGHT Cursor key.
Trim Adjust (Installation only): Select Trim. Press the RIGHT or LEFT Cursor keys to adjust the trim.
Pause: Select Pause Ulterra. Press the RIGHT Cursor key.

Stow the Motor

Use the following instructions to stow the Ulterra trolling motor.
WARNING! As soon as Stow Ulterra is selected, the motor will stow automatically. Before you deploy or stow the motor, confirm
the motor is clear from obstructions and has a clear path of travel. The propeller is disabled while the motor is being trimmed to
prevent accidental contact with the rotating propeller.
1. Press the POWER key.
2. Select Stow Ulterra.
3. Press the RIGHT Cursor key.

Pause Deploying or Stowing

Use the following instructions to pause the trolling motor while it is being deployed or stowed.
1. Press the POWER key.
2. Select Pause Ulterra.
3. Press the RIGHT Cursor key.
To resume deploying, see Deploy the Motor.
To resume stowing, see Stow the Motor.
Adjust the Trim
Use the following instructions to adjust the trim. The Trim menu is available when the motor is deployed.
1. Press the POWER key.
2. Select Trim.
3. Press the RIGHT or LEFT Cursor keys to adjust the trim.
The control head will save the most-recent trim setting and apply it when the motor is deployed again, even after power off.
U T
LTERRA ROLLING
M
OTOR