Chevrolet 1973 Overhaul Manual page 420

Fig. 152T--lnstalling Detent Roller and Spring
Assembly
NOTE: The TCS wire is routed from the case
electrical connector around the solenoid
assembly and under the governor pipe to
pressure switch.
7. Connect the lead wire to the pressure switch
assembly.
INSTALLATION OF FILTER AND INTAKE
PIPE
1. Install case to intake pipe "O" ring seal on intake
pipe and assemble into filter assembly.
2. Install filter and intake pipe assembly (fig. 8T).
Fig. 1 5 3 T -ln s ta llin g Vacuum M odulator and Valve
A U T O M A T IC T R A N S M IS S IO N
Fig. 154T--lnstalling Governor Assembly
NOTE: It is recommended that the filter be
replaced, rather than cleaned, whenever the
transmission is disassembled.
3. Install filter retainer bolt (fig. 7T).
4. Install new bottom pan gasket and bottom pan, with
attaching screws. Torque to 12 ft. lbs.
INSTALLATION OF MODULATOR VALVE
AND VACUUM MODULATOR
1. Install modulator valve into case, stem end out (fig.
153T).
2. Install "O " ring seal on vacuum modulator.
Fig. 155T-lnstalling Speedometer Driven Gear and
Sleeve
7 A -11 7
OVERHAUL MANUAL