Chevrolet 1973 Overhaul Manual page 318

1. Valve to Shaft
Retaining Snap Ring
2. Valve
3. Shaft
4. Urethane W asher
5. Body
6. Outer W eigh t
7. Spring
assembly bolts and separate the body, hub and
gasket. Remove the two seal rings.
Inspection
Clean all parts thoroughly in a solvent and air dry.
Check condition of all component parts of the assembly.
Replace any bent, damaged or scored parts. Body and
hub must be replaced as a unit.
Assembly
1. Reassemble governor weights and reinstall in body
bore. Replace seal rings on hub.
8 Inner W e ig h t
.
9. Inner W e ig h t to Outer
W e ig h t Retaining
Snap Ring
10.
O uter W e ig h t to
Body Retaining Snap
Ring
Fig. 26PG--Governor--Exploded View
Slide hub into place on output shaft and lock into
place with the drive screw. Install gasket and
governor body over output shaft, install governor
shaft, line up properly with output shaft and install
body attaching bolts. Torque to specification.
NOTE: Place transmission selector lever in
PARK to keep shaft from turning while
tightening these bolts.
Check the governor weight for free fit in body after
3.
the four attaching bolts are torqued. If the weight
sticks or binds, loosen the bolts and retorque.
A U T O M A T IC T R A N S M IS S IO N
9
11. Body to Hub Screws
and Lock W ashers
12. Gasket
13. Hub Drive Screw
14. Hub
15. Hub Oil Seal Rings
16. Inner W e ig h t to Shaft
Retaining Snap Ring
7A-15
16
I \
J Zj
OVERHAUL MANUAL