Chevrolet 1973 Overhaul Manual page 357

7 A -5 4 A U T O M A T IC T R A N S M IS S IO N
Stator Shaft Front Bushing
With stator shaft properly supported, remove front
bushing using tool J-21465-16 and slide hammer with
adapter J-2619-01 (fig. 96M). Using tool J-21242-7 and
drive handle J-8092, install bushing to .250" from face
(fig. 97M).
Stator Shaft Rear Bushing
With stator shaft properly supported, remove front
bushing (fig. 98M). Place tool J-21424-7 and drive handle
J-8092 with extension J- 21465-13 through front of stator
shaft and drive out two (2) rear bushings. Using tool
J-23062-2 and extension J-21465-13, install innner
bushing to approximately 1-5/32" below front face and
PUMP C O V E R
A N D STATO R
SH AFT ASSEM BLY
Fig. 96M--Removing Stator Shaft Front Bushing
J - 8 0 9 2
DRIVE
HANDLE
PUMP C O V E R
A N D STATOR
SHAFT ASSEMBLY
Fig. 9 7 M -ln s ta llin g Stator Shaft Front Bushing
21465-15
J-2 6 1 9 -4
ADAPTER
B O D Y PUMP
J - 2 1 4 2 4 - 7
PUMP
BODY
outer bushing 3/32" below front face (fig. 98M). Install
new front bushing (fig. 97M).
Input Ring Gear Bushing
With input ring gear properly supported, remove
bushing using tool J-23062-5 and drive handle J-8092.
Using tool J-23062-5 and drive handle J-8092, install
bushing to approximately 1/16" below rear face inside
gear end (fig. 99M).
Sun Gear Bushing
With sun gear properly supported, remove two (2) sun
gear bushing using tool J-23062-3 and drive handle
J-8092 with extension J-21465- 13. Using tool J-23062-3
and drive handle J-8092, install sun gear bushings to
.010" below surface at either end (fig. 100M).
Reaction Carrier Bushing
With reaction carrier properly supported, remove
bushing using tool J-23062-3 and drive handle J-8092.
Using tool J-23062-3 and drive handle J-8092, install
bushing flush to or .010" below inside face.
Direct Clutch Bushing
With direct clutch drum properly supported, remove
bushing (fig. 101). Using tool J-23329 and drive handle
J-8092, install direct clutch drum bushing (fig. 102M).
TRANSM ISSIO N ASSEMBLY
When servicing transmission, use only transmission oil
or petroleum jelly as lubricants to retain bearings or
J-23062-2
Fig. 9 8 M --ln sta lling Inner and O uter Stator Shaft
Bushing
OVERHAUL MANUAL