Chevrolet 1973 Overhaul Manual page 397

7 A -9 4 A U T O M A T IC T R A N S M IS S IO N
INTERMEDIATE CLUTCH
ROLLER ASSEMBLY
DIRECT CLUTCH H O U SIN G
AND CAM ASSEMBLY
Fig. 9 2T -Installing Intermediate Clutch Roller
Assembly
NOTE: Outer race should not turn counter­
clockwise after installation. (See Figure 93T).
12. Install intermediate clutch retainer and snap ring
(fig. 94T and 95T).
14. Place direct clutch assembly over center support
and air check operation of direct clutch (fig. 96T).
NOTE: If air is applied through reverse
passage, (right oil feed hole) it will escape
from direct clutch passage (left oil feed hole).
This is considered normal. Apply air through
left oil feed hole to actuate piston and move
direct clutch.
INTERMEDIATE CLUTCH
OUTER RACE
ROLLER
ASSEM BLY
INTERMEDIATE
CLUTCH
Fig. 92T A-Installing Intermediate Clutch Outer Race
to Direct Clutch
Fig. 93T-Intermediate Roller Clutch Rotation
Fig. 94T-lnsta!ling Intermediate Clutch Retainer
DISASSEMBLY, INSPECTION AND RE­
ASSEMBLY OF CENTER SUPPORT
Disassembly
1. Remove four (4) teflon oil seal rings from the
center support (fig. 97T).
2. Compress spring retainer and remove snap ring
(fig. 98T).
3. Remove spring retainer (Fig. 98TA) and three (3)
clutch release springs (Fig. 98TB).
4. Remove intermediate clutch spring guide (Fig.
98TC).
OVERHAUL MANUAL