Avaya S8500 User Manual page 43

Figure 18: Advanced Ethernet setup
1
In the Data Rate field [default: Auto]: Used to specify the amount of data to be transferred per
second over a LAN connection. Possible selections from the drop-down menu are: Auto, 10 Mb,
and 100 Mb.
2
In the Duplex field [default: Auto]: Used to enter the type of communication channel that is used
in your network. From the drop-down menu, select one of the following:
•
Full: Data is carried in both directions at one time.
•
Half: Data is carried in one direction at a time.
•
Auto: This option allows automatic detection of the duplex type.
3
In the Maximum transmission unit field [default: 1500 bytes]: Used to specify the maximum
packet size, in bytes, for your network interface.
4
In the Locally administered MAC address field [0.0.0.0] : A locally administered MAC
overrides the burned-in MAC address. The locally administered MAC address must be in the
following format:
•
Hexadecimal value from 000000000000 through FFFFFFFFFFFF.
•
In the form of XX:XX:XX:XX:XX:XX where X is a number between zero and nine.
5
In the Burned-in MAC address field: This is a read-only field that contains the unique factory
MAC address burned-in at the factory.
NOTE:
The RSA does not support the use of a multicast address. When a multicast address is used
the least significant bit of the first byte is set to one.
6
Click Save to save the changes.
7
In the navigation panel, click Restart ASM under the ASM Control heading to activate the
changes.
Avaya Remote Supervisor Adapter User Guide
November 2003
Using the Avaya Remote Supervisor Adapter
Alerts
43