Alert Fowarding; Configuring Global Remote Alert Settings - Avaya S8500 User Manual

•
Number: Type a telephone number, IP address, or host name if one of the following selections
were made in the Notification Method field:
•
Numeric pager: Type the telephone number followed by a comma, and then personal
identification number (PIN).
•
Alphanumeric pager: Only a telephone number is required for an alphanumeric pager.
The PIN number is a separate entry that is entered in the PIN field.
•
IBM Director over modem: In the case where an Avaya service contract is in place or the
system is under warranty, this field may contain the number for an Avaya service center.
•
SNMP over PPP
•
E-mail over PPP
•
PIN: If an alphanumeric pager was selected as the form of notification, enter a PIN.
•
E-Mail Address: If e-mail over LAN or e-mail over PPP was selected as the form of notification,
enter an e-mail address.
NOTE:
For E-mail over LAN or E-mail over PPP notification to work properly, type the host
name or IP address for the SMTP in Network Protocols. For more information on
configuring the SMTP refer to
2
Click Save to save any additions or modifications to the Remote Alert Recipients fields.
3
Click Generate Test Alert to generate a test alarm to all configured remote alarm recipients.

Alert fowarding

This option does not apply in a S8500 Media Server configuration.

Configuring global remote alert settings

The Global Remote Alert Settings fields define the number of times an alert retries and the delay time
between retries. These global settings effect every alert recipient.
To configure the global remote alert settings:
1
In the navigation pane, select Alerts under the ASM Control heading.
2
Scroll down to the Global Remote Alert Settings section (see
settings,
Figure 12: Global remote alert settings
Avaya Remote Supervisor Adapter User Guide
November 2003
on page 33).
Using the Avaya Remote Supervisor Adapter
Network protocols.
Figure 12, Global remote alert
Alerts
33