Dual-Camera System - Sony HDCU2000 Operation Manual

Dual-Camera System

Two pairs of cameras and camera control units are connected
via an optical fiber cable for "High Bit Rate" transmission.
Connection example
Primary camera (HDC2500)
LEVEL MIC PROD LEVEL MIC PROD
INCOM INCOM
REAR ON REAR ON
FRONT OFF ENG FRONT OFF ENG
INTERCOM 1 INTERCOM 2
DC OUT EARPHONE
REMOTE
TRACKER CRANE
PROMPTER
RET CTRL
FRONT MIC AES/EBU
LINE MIC LINE MIC
+48V +48V
TEST
OFF OFF
AUDIO IN
DC IN 10.5-17V
CH1 CH2
Secondary camera (HDC2500)
LEVEL MIC PROD LEVEL MIC PROD
REAR ON INCOM REAR ON INCOM
FRONT OFF ENG FRONT OFF ENG
INTERCOM 1 INTERCOM 2
DC OUT EARPHONE
REMOTE
TRACKER CRANE
PROMPTER
RET CTRL
FRONT MIC AES/EBU
LINE MIC LINE MIC
+48V +48V TEST
OFF OFF
AUDIO IN
DC IN 10.5-17V
CH1 CH2
1)
DC power
1) A dedicated power source is required for the secondary
camera. No power is supplied from the camera control unit.
Settings
Primary camera
MAINTENANCE menu, <SDI OUT> page:
Set SDI-1 OUT to HD PROMPTER.
Set SDI-2 OUT/IN to HD TRUNK/RET IN.
Secondary camera
MAINTENANCE menu, <SDI OUT> page:
Set COAX MODE to ON.
Set SDI-2 OUT/IN to HD TRUNK/RET IN.
22
Connections and Settings
Optical fiber cable (High Bit Rate)
CCU
SDI 1
/GEN
LOCK
OUT
SDI 2
SDI
MONI
SDI 1
/GEN
LOCK
OUT
SDI 2
SDI
MONI
Notes
• The primary camera and the secondary camera must be in
genlock status.
• Do not connect any optical fiber cable to the secondary
system.
Reference signal
REFERENCE
REFERENCE
HD
HD TRUNK
PROMPTER
OUT
IN
BNC cables
BNC cable
(HD-SDI)
HD
HD TRUNK PROMPTER
OUT IN REFERENCE
Primary camera control unit
Format: Set it to a Single Link format.
CCU CONFIGURATION menu, <TRANSMIT> page: Set
CABLE to CAMERA CABLE.
Secondary camera control unit
Format: Set it to a Single Link format.
CCU CONFIGURATION menu, <TRANSMIT> page: Set
CABLE to COAX.
CAMERA
Primary camera control unit
(HDCU2000)
Secondary camera control unit
(HDCU2000)