Sony HDCU2000 Operation Manual page 43

CCU
CONFIGURATION
Page name Item
Page No.
<INTERCOM> INTERCOM CH
C08
SYSTEM INTERFACE
PRODUCER
ENGINEER
PGM1 INPUT
PGM2 INPUT
<FRONT INCOM>
C09
INCOM MIC
SIDE TONE
PGM MIX
PGM SEL
<PROMPT/TRUNK 1> PROMPTER CH
C10
TRUNK LINE
AUX REMOTE
Settings
1CH, 2CH
4WIRE, RTS, CLEAR COM
CANCEL LVL –99 to 99 0
TERMINATION (OFF), ON
4WIRE, RTS, CLEAR COM
CANCEL LVL –99 to 99 0
TERMINATION (OFF), ON
–20, 0, +4 dBu
–20, 0, +4 dBu
(MIC ON), (MIC OFF), (PGM ON)
(PROD), (ENG), (PRIVATE)
CARBON, ECM, DYNAMIC
MIC TYPE BALANCE, UNBALANCE
MIC GAIN –6dB, 0dB, +6dB
0 to 99 50
OFF, INCOM+PGM, L-INCOM/R-
PGM
PGM1, PGM2, PGM1 + PGM2
PGM1 LVL 0 to 99 50
PGM2 LVL 0 to 99 50
1CH, 2CH
CH 1CH, 2CH
IF 232C, 422A
RATE (38Kbps), (19Kbps), (75Kbps),
(150Kbps)
DISABLE, ENABLE
Description
Selects the intercom channel number.
Sets the producer line intercom system.
Sets the side tone cancel level.
Connects to a 200 Ω terminator, if ON is selected
while 2-wire intercom interface (RTS or CLEAR
COM) is used.
(OFF): Displayed when 4WIRE is selected in
SYSTEM I/F. (Display only)
Sets the engineer line intercom system.
Sets the side tone cancel level.
Connects to a 200 Ω terminator, if ON is selected
while 2-wire intercom interface (RTS or CLEAR
COM) is used.
(OFF): Displayed when 4WIRE is selected in
SYSTEM I/F. (Display only)
Sets the PGM1 input level.
Sets the PGM2 input level.
CCU front panel MIC/PGM switch position. (Display
only)
CCU front panel INTERCOM switch position.
(Display only)
Sets the headset microphone connected to the
INTERCOM connector on the front panel.
CARBON: Carbon microphone (power supply, 20dB
gain)
ECM: Electret condenser microphone (power
supply, 40dB gain)
DYNAMIC: Dynamic microphone (no power supply,
60dB gain)
Sets the headset microphone connected to the
INTERCOM connector on the front panel.
BALANCE: Balanced microphone
UNBALANCE: Unbalanced microphone
Sets the input gain.
Sets the side tone level.
OFF: Signals are not mixed.
INCOM+PGM: INCOM and PGM signals are mixed.
L-INCOM/R-PGM: Outputs an INCOM signal
through the left channel and a PGM signal through
the right.
Selects the PGM type.
Sets the PGM1 level.
Sets the PGM2 level.
Sets the number of prompter lines. (HDCU2500 is
locked to 1CH.)
Sets the number of channels to be used.
Sets the communication line mode.
Displays the TRUNK line. (Display only)
Sets whether or not AUX REMOTE is used.
43
Setup Menu