Sony HDCU2000 Operation Manual page 42

CCU
CONFIGURATION
Page name
Page No.
<MONITOR 2>
C04
<I/F SETUP>
C05
<MIC GAIN>
C06
<AUDIO OUT>
C07
42
Setup Menu
Item Settings
LEVEL GATE ---, 1&2, 1, 2, OFF
Y-LEVEL1 0 to 108% 49 61
–99 to 99 –25
Y-LEVEL2 0 to 108% 74 108
–99 to 99 –25
GATE-MARKER ---, ON, OFF
–99 to 99 0
MODULATION ---, ON, OFF
–99 to 99 0
MARKER ON, OFF
4:3, 13:9, 14:9, EU VISTA, VISTA,
CINEMA, FOLLOW DC
BOARD FRONT, REAR
SLOT1 BOARD NAME DISPLAY
SLOT2 BOARD NAME DISPLAY
SLOT3 BOARD NAME DISPLAY
SLOT4 BOARD NAME DISPLAY
SLOT5 BOARD NAME DISPLAY
SLOT6 BOARD NAME DISPLAY
DSUB-15 MIC-REMOTE, WF-REMOTE
CHARA/SYNC CHARACTER, SYNC
REAR PREVIEW MOMENTARY, TOGGLE
CAM MIC GAIN
CH1 ---, 20, 30, 40, 50, 60 dB
CH2 ---, 20, 30, 40, 50, 60 dB
DELAY 0 to 3840FS
AES/EBU OUT MIC 1/2, AES, EBU
ANALOG OUT MIC 1/2, AES, EBU
CH1 LEVEL 0, +4, –20
ADJUST –99 to 99 0
CH2 LEVEL 0, +4, –20
ADJUST –99 to 99 0
Description
1&2: Displays level gate 1 & 2.
1: Displays level gate 1.
2: Displays level gate 2.
---: Displayed when camera not connected, video
output not set to CAMERA, or video output is set to
CAMERA and GATE MARKER is ON. (Display only)
Sets the level gate 1 minimum and maximum
detection level.
Sets the level gate 1 zebra range.
Sets the level gate 2 minimum and maximum
detection level.
Sets the level gate 2 zebra range.
Sets the gate signal display to ON/OFF.
---: Displayed when a camera is not connected.
Sets the gate signal level.
Sets the 4:3 aspect ratio mask function to ON/OFF
when EDGE CROP is set to ON.
---: Displayed when a camera is not connected.
Sets the mask video level.
Sets the marker signal to ON/OFF.
Selects a superimposed marker signal.
Display only
Detects and displays the boards installed to the
front/rear of the CCU. (Display only)
Sets the output for the MIC REMOTE connector.
(HDCU2500 only)
Sets the output for the CHARACTER/SYNC
connector. (HDCU2500 only)
Selects the REAR PREVIEW output operating
mode.
Sets the microphone gain.
Settings vary depending on microphones.
---: Displayed when a camera is not connected.
(Display only)
Sets the camera's microphone output phase.
Selects the MIC OUT DIGITAL output. (HDCU2000
only)
Selects the MIC OUT ANALOG output.
Sets the AUDIO CH1 output level.
Sets the AUDIO CH2 output level.