Qos Wrr Group Sp - HP HSR6800 Command Reference Manual

Use undo qos wrr to disable WRR queuing.
Syntax
qos wrr
undo qos wrr
Default
An interface uses SP queuing.
Views
Interface view, port group view
Default command level
2: System level
Parameters
None.
Usage guidelines
Settings in interface view take effect on the current interface. Settings in port group view take effect on all
ports in the port group.
You must enable WRR queuing before you can configure WRR queuing parameters for a queue on an
interface.
Once you enable WRR queuing on an interface, all its queues are assigned to the default WRR group,
each with a default weight.
Examples
# Enable WRR queuing on GigabitEthernet 1/0/1.
<Sysname> system-view
[Sysname] interface gigabitethernet 1/0/1
[Sysname-GigabitEthernet1/0/1] qos wrr

qos wrr group sp

Use qos wrr group sp to assign a queue to the strict priority (SP) group on a WRR-enabled interface.
Use undo qos wrr group sp to remove a queue from the SP group on a WRR-enabled interface.
Syntax
qos wrr queue-id group sp
undo qos wrr queue-id group sp
Views
Interface view, port group view
Default command level
2: System level
Parameters
queue-id: Specifies a queue by its ID in the range of 0 to n- 1 (n is the maximum number of queues on an
interface and varies by device).
117