Gts Percent - HP HSR6800 Command Reference Manual

Default command level
2: System level
Parameters
cir committed-information-rate: CIR in kbps, which specifies the average traffic rate.
cbs committed-burst-size: CBS in bytes, which specifies the size of bursty traffic when the actual average
rate is not greater than CIR.
ebs excess-burst-size: EBS in bytes. The default is 0.
queue-length queue-length: Maximum queue length. The default is 50.
Usage guidelines
A QoS policy that references a behavior with GTS configured can be applied in only the outbound
direction of an interface or PVC.
A policy referencing a behavior with GTS configured overwrites the qos gts command on the interface or
PVC, if both are configured.
If this command is configured for the same traffic behavior for multiple times, the last configuration takes
effect.
GTS for software forwarding does not support IPv6.
Examples
# Configure a GTS action in absolute value in traffic behavior database. The GTS parameters are as
follows: CIR is 200 kbps, CBS is 50000 bytes, EBS is 0, and the maximum buffer queue length is 100.
<Sysname> system-view
[Sysname] traffic behavior database
[Sysname-behavior-database] gts cir 200 cbs 50000 ebs 0 queue-length 100
Related commands
qos policy
•
• traffic behavior
classifier behavior
•

gts percent

Use gts percent to configure a GTS action in percentage in a traffic behavior.
Syntax
gts percent cir cir-percent [ cbs cbs-time [ ebs ebs-time ] ]
undo gts
Views
Traffic behavior view
Default command level
2: System level
Parameters
cir cir-percent: Sets the CIR in percentage, in the range of 0 to 100. The actual CIR value is cir-percent ×
interface bandwidth.
47