Figure 16
1. Actuator pin in the groove
on the drive gear
2. Clutch assembly
3. Install the cover onto the groomer housing,
inserting the actuator pin of the clutch assembly
into the groove of the drive gear
4. Secure the cover with 5 flange-head bolts
(Figure
16) and torque them to 9.6 to 10.5 N∙m
(85 to 95 in-lb).
g020848
3. Flange-head bolt
4. Gasket
(Figure
16).
7
Installing the Groomer
on the Right Side of the
Machine
Parts needed for this procedure:
1
Bearing Adapter
2
Spacer
1
Groomer-plate assembly
1
Adapter ring
2
Bolt (1/4 x 3-3/4 inches)
2
Star washer
2
Fastener retainer
1
Weight
Procedure
1. Remove the 4 bolts securing the reel-drive-belt
cover to the right, side plate and remove the
cover
(Figure
17).
g017184
1. Reel-drive-belt cover
2. Loosen the idler pulley to relieve the belt tension
and remove the reel-drive belt from the pulleys
(Figure
18).
8
Figure 17
1
g017184