Advertisement
4
Installing the Drive Gear
Parts needed for this procedure:
1
Shaft assembly
1
Drive gear
–
Synthetic grease
Procedure
1. Remove the reel-bearing locknut from the reel
shaft
(Figure
10).
Note:
The reel-bearing locknut has
right-handed threads.
Figure 10
1. Reel-bearing locknut
2. Secure the reel from turning with a wood block.
3. Thread the shaft assembly onto the reel-shaft
extension
(Figure
1. Shaft assembly
2. Drive gear
11).
1
4
g022024
Figure 11
3. Groove
4. 40 tooth idler gear
4. Secure the reel from turning with a wood block
and torque the shaft assembly to 54 to 81 N∙m
(40 to 60 ft-lb).
5. Apply synthetic grease (supplied with the kit) to
the male spline of the shaft assembly
11).
6. Slide the drive gear with the groove oriented
outward onto the shaft assembly
7. Install the 40 tooth idler gear
5
Setting the Groomer for
Forward Rotation (Optional)
Parts needed for this procedure:
1
Forward Rotation Kit-obtain separately
Procedure
The groomer comes designed to rotate in the opposite
direction of the reel. Optionally, you can set it to rotate
in the same direction as the reel by obtaining the
Forward Rotation Kit using the following procedure:
1. Remove the 2 socket-head bolts and locknuts
from the cover
g022029
g022029
2
3
1. Socket-head bolts—keep
one
2. Keep one of the bolts and discard the rest of the
g022024
fasteners.
3. Remove the center gear assembly, saving the
gear and discarding the bushing and bolt
13).
6
(Figure
(Figure
11).
(Figure
12).
Figure 12
2. Locknuts—discard
(Figure
11).
g020880
(Figure
Advertisement
