Figure 13
1. Bushing—discard
2. Center gear—keep
4. Install the socket-head bolt you removed from
the cover into the hole where the center gear
was installed
(Figure
Figure 14
1. Socket-head bolt previously removed from the cover
5. Press fit the center gear removed previously
onto the hub
(Figure
Important:
Support the inner race of the
gear bearing while pressing it onto the hub.
3. Bolt—discard
14).
15).
g020881
1. Gear assembly—from the
forward rotation kit
2. Flange-head bolt—from
the forward rotation kit
6. Install the center gear and hub assembly and
the gear assembly, from the forward rotation kit,
to the cover with 2 flange-head bolts as shown
in
Figure
6
Installing the
Groomer-Housing Cover
Parts needed for this procedure:
1
Groomer-housing cover assembly
1
Gasket
5
Flange-head bolt (1/4 x 3/4 inch)
g020882
1
Synthetic grease (3.0 oz)
Procedure
1. Coat the teeth of the gears with the synthetic
grease supplied with the kit. Use the remaining
grease to fill in the area around the gears.
2. Place the gasket over the dowel pins on the
groomer housing
7
Figure 15
3. Gear hub—from the
forward rotation kit
4. Center gear assembly
15.
(Figure
16).
g020883