Advertisement
6. Install the O-ring into the back of the groomer
housing
(Figure 6
lubricate the exposed surfaces of the O-ring with
synthetic grease (supplied with the kit).
Figure 7
1. O-ring
7. Insert the adapter ring into the reel bearing
housing
(Figure 6
Figure 8
1. Groomer housing
2. Slot cover
3. O-ring
4. Adapter ring
8. Insert the 2 flat-head screws (3/8 x 2 inch)
through the bearing adapter and position the
spacers on the ends of the screws
Figure
8).
9. Align the bearing adapter, spacers, and screws
with the bronze bushing and the slots in the
groomer housing.
and
Figure
7) and lightly
and
Figure 8
).
5. Spacer
6. Flat-head screw
7. Locknut
8. Bearing adapter
(Figure 6
10. Slide the bearing adapter through the bronze
bushing and the screws through the slots in the
groomer housing assembly
8).
Important:
is oriented as shown in
g020843
1. Bearing adapter
11. Place the slot cover over the screws and up
against the lubricated O-ring
12. Ensure that the flat edge of the slot cover is
oriented at the bottom.
13. Insert the flat-head screws through the
reel-bearing housing and secure them with
locknuts.
14. Torque the locknuts to 31 to 37 N∙m (23 to 27
ft-lb)
(Figure 6
Note:
To gain access to the locknuts you may
need to move or remove the bedbar.
15. Mount the adjustment knob mounting block to
the left side plate with the bolt (3/8 x 5/8 inch)
g020844
and curved washer you removed previously
(Figure
6).
16. If you are installing this kit on a Greensmaster
800 mower with a serial number prior to
230999999, a Greensmaster 1000 mower
with a serial number prior to 229999999, or
a Greensmaster 1600 mower with a serial
number prior to 260001401, install the left,
bedbar-adjuster frame to the side plate with
the bolts and washers you removed previously
and
(Figure
4).
5
(Figure 6
Ensure that the bearing adapter
Figure
9.
Figure 9
(Figure
and
Figure
8).
and
Figure
g020854
6).
Advertisement
