Advertisement
sides of the machine with the 2 taper-face
bolts, using the rear sets of mounting holes
in the side plates.
5. Install the height-of-cut arms as follows:
•
Greensmaster 1600 mowers—obtain 2 new
height-of-cut arms from your Authorized Toro
Distributor and install them onto the roller
assembly and side plates with the fasteners
removed previously
•
Greensmaster 800 and 1000 mowers—rotate
the height-of-cut arms you removed
previously to the forward position and install
them onto the roller assembly and side
plates with the fasteners removed previously
(Figure
2).
g017179
Figure 2
1. Height-of-cut arm in the forward position
(Figure
2).
1
g017179
3
Installing the Groomer
Housing
Parts needed for this procedure:
1
Groomer-housing assembly
2
Flat-head screw (3/8 x 2 inches)
2
Locknut (3/8 inch)
1
Bearing adapter
2
Spacer
1
O-ring
-
Synthetic grease
1
Slot cover
1
Adapter ring
Procedure
1. Remove the 2 bolts and locknuts securing the
end cap to the left, reel-bearing housing and the
side plate.
2. Remove and retain the end cap and fasteners
for use if you ever remove the groomer
3).
G017288
1
1. End cap
2. Bedbar-adjuster frame
3. If you are installing this kit on a Greensmaster
800 mower with a serial number prior to
230999999, a Greensmaster 1000 mower
with a serial number prior to 229999999, or
3
2
4
Figure 3
3. Spring tension screw
4. Bolts and washers
(Figure
3
g017288
Advertisement
