Genie GS-1530/32 Service And Repair Manual page 160

Service and Repair Manual
Scissor Components
Full Load Calibration: Part 1
1 Fully charge the batteries and check the
hydraulic fluid level.
Note: The hydraulic fluid level must be between the
FULL and ADD marks on the hydraulic tank.
2 Apply a thin layer of dry film lubricant to the
area of the chassis and platform, where the
scissor arm wear pads make contact.
3 Chock both sides of the wheels at the steer
end of the machine.
4 Using a suitable lifting device, place a test
weight corresponding to the machine
maximum load, in the center of the platform
deck. Secure the weight to the platform. Refer
to the chart below.
GS-1530 and GS-1532
GS-1930 and GS-1932
GS-2032
GS-2632
GS-3232
Note: In the event of frequent nuisance trips
occurring after calibrating a GS-3232 machine, it is
recommended to recalibrate the machine, full load
and no load, with 250 kg of weight in the platform.
GS-2046
GS-2646
GS-3246
GS-4047
5 Turn the key switch to ground control.
6 At the ground controls, press and hold the
Menu Up and Menu Down buttons.
7 While pressing both buttons down, pull out the
red Emergency Stop Button.
144
8
9
10 Use the Menu Up or Menu Down buttons to
11 Press the Enter button to select Platform
12 Use the Menu Up or Menu Down buttons to
13 Press the Enter button to select Platform
14 Confirm the Platform Overload Calibrate
272 kg
15 Use the Menu Up or Menu Down buttons to
227 kg
363 kg
16 Press the Enter button to select Full Load
227 kg
227 kg
17 Press the Enter button to confirm rated load is
18 At the ground controls, press and hold the
544 kg
19 All Models except GS-4047: When the
454 kg
317 kg
350 kg
Note: If at any point the Menu Enter button is
released before the message appears on the LCD
screen, the calibration procedure will restart at step
18.
GS-30 • GS-32 • GS-46 • GS-47
Release the Menu Up and Menu Down
buttons after the ground controller powers up.
Use the Menu Up or Menu Down buttons to
scroll to, Select Option. Press the Enter
button.
scroll to Platform Overload.
Overload.
scroll to Platform Overload Calibrate.
Overload Calibrate.
selection by pressing the Enter button again.
select Full Load calibration.
calibration.
in the platform.
Function Enable and Platform Up buttons until
the platform reaches maximum height.
platform reaches maximum height, press the
ground controls Enter button. Allow the ground
controls to gather data. GS-4047 only: Press
and hold the Menu Enter button to determine
the maximum height. The machine will lower
for 1.2 seconds and then raise in 1.2 second
durations, until maximum height is reached.
When the platform reaches the maximum
height, a message will appear on the LCD
screen to release the Menu Enter button.
April 2017
Part No. 1272217