Genie GS-1530/32 Service And Repair Manual page 149

April 2017
3 Lift the safety arm, move it to the center of the
scissor arm and rotate down to a vertical
position.
1 lift cylinder
2 orifice(schematic item O)
3 connector fitting
4 hydraulic hose
5 pressure transducer(schematic item R)(if
equipped)
6 manual lowering cable
7 solenoid valve(schematic item N)
8 cable mount bracket
4 Lower the platform onto the safety arm.
Crushing hazard. Keep hands
clear of the safety arm when
lowering the platform.
5 Using a suitable lifting device, support the link
stack at the steer end of the machine.
Part No. 1272217
6
7
8
9
10 Loosen the adjustment nuts on the solenoid
Note: During assembly, the manual platform
lowering cable needs to be properly adjusted.
Refer to Repair Procedure, How to Adjust the
Manual Platform Lowering Cable.
11 Remove the fasteners securing the manual
12 Tag, disconnect and plug the hydraulic hoses
GS-30 • GS-32 • GS-46 • GS-47
Service and Repair Manual
Scissor Components
At the ground controls, turn the key switch to
the off position and push in the red Emergency
Stop button to the off position.
Disconnect the battery pack from the machine.
Electrocution/burn hazard.
Contact with electrically charged
circuits could result in death or
serious injury. Remove all rings,
watches and other jewelry.
Tag and disconnect the wiring from the
solenoid valve coil at the barrel end of the lift
cylinder.
If equipped, tag and disconnect the three-pin
connector from the pressure transducer
harness. To remove the pressure transducer
refer to Repair Procedure, How to Remove the
Pressure Transducer (if equipped).
valve and disconnect the manual lowering
cable from the valve.
lowering cable mount bracket to the cylinder.
Remove the bracket from the cylinder.
on the lift cylinder. Cap the fittings on the
cylinder.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
133