Genie GS-1530/32 Service And Repair Manual page 131

April 2017
91 Use a soft metal drift to remove the number
2 pivot pin (index #27) from the non-steer end
of the machine. Remove the number 2 outer
arm at the ground control side (index #26)
from the machine.
The number 2 outer arm at the
ground control side (index #26)
may become unbalanced and fall
if not properly supported when
the pivot pin is removed.
92 Attach a lifting strap from an overhead crane
to the number 2 outer arm at the battery side
(index #26).
93 Remove the retaining fasteners from the
number 2 center pivot pin (index #11) at the
battery side.
94 Place a rod through the number 2 center pivot
pin at the battery side (index #11) and twist to
remove the pin.
Crushing hazard. The number
2 outer arm (index #26) may
become unbalanced and fall if
not properly supported when the
pivot pin is removed.
95 Remove the number 2 outer arm (index #26)
from the machine.
Crushing hazard. The number
2 outer arm (index #26) may
become unbalanced and fall if
not properly supported when
removed from the machine.
96 Attach a lifting strap from an overhead crane
to the number 2 inner arm (index #25). Raise
the arm to a vertical position.
Part No. 1272217
97 Remove the retaining fasteners from the
98 Use a soft metal drift to remove the number
99 Attach a lifting strap from an overhead crane
100 Raise the number 1 inner arm (index #14)
101 Place a 4 x 4 x 48 inch / 10 cm x 10 cm x
102 Lower the scissor arms onto the block that
103 Attach a lifting strap from an overhead crane
104 Tag, disconnect and plug the hydraulic hose
GS-30 • GS-32 • GS-46 • GS-47
Service and Repair Manual
Scissor Components
number 2 pivot pin at the steer end of the
machine (index #12).
2 pivot pin (index #12) from the steer end of
the machine. Remove the number 2 inner arm
(index #25) from the machine.
Crushing hazard. The number
2 inner arm (index #25) may
become unbalanced and fall if
not properly supported when the
pivot pin is removed.
to the number 1 inner arm (index #14).
approximately 2 feet / 60 cm.
1.2 m long block across both sides of the
chassis under the number 1 center pivot pin
(index #13).
was placed across the chassis.
Bodily injury hazard. Keep hands
clear of moving parts when
lowering the scissor arms.
to the lug of the rod end of the lower lift
cylinder.
on the lower lift cylinder. Cap the fittings on the
cylinder.
Bodily injury hazard. Spraying
hydraulic oil can penetrate and
burn skin. Loosen hydraulic
connections very slowly to allow
the oil pressure to dissipate
gradually. Do not allow oil to
squirt or spray.
115