Spb I-Sid - HP FlexFabric 5930 Series Command Reference Manual

Parameters
b-mac-conflict: Specifies the B-MAC conflict notification. This notification is generated when a remote
B-MAC conflicts with a local B-MAC.
spsource-conflict: Specifies the SPSource ID conflict notification. This notification is generated when a
remote SPSource ID conflict with the local SPSource ID.
Usage guidelines
The command enables both B-MAC conflict and SPSource ID conflict notifications if you execute the
command without any keywords.
To send SPBM notifications to an NMS, you must also configure SNMP as described in Network
Management and Monitoring Configuration Guide.
Examples
# Disable SNMP notifications for SPBM.
<Sysname> system-view
[Sysname] undo snmp-agent trap enable spbm

spb i-sid

Use spb i-sid to create an SPB VSI and enter SPB I-SID view.
Use undo spb i-sid to restore the default.
Syntax
spb i-sid i-sid
undo spb i-sid
Default
The device does not have SPB VSIs.
Views
VSI view
Predefined user roles
network-admin
Parameters
i-sid: Specifies an I-SID for the VSI, in the range of 255 to 16777215.
Usage guidelines
You must assign a unique I-SID to each SPB VSI for identification. The name of an SPB VSI can be
different on different SPBM nodes, but its I-SID must be the same across an SPBM network. For more
information about VSIs, see MPLS Configuration Guide.
You can configure one SPB I-SID and one PBB I-SID for an VSI, but the two I-SIDs cannot be the same.
For more information about PBB, see Layer 2—LAN Switching Configuration Guide.
The I-SID for the fast-channel VSI is 255. To use the fast-channel feature, you must create a VSI and
assign I-SID 255 to the VSI. You cannot associate an Ethernet service instance with the VSI that uses I-SID
255 for data transmission.
Examples
# Assign SPB I-SID 256 to VSI vpn1 and enter SPB I-SID view.
65