Table of Contents
Advertisement
Configuration Files
Note
Warning
This appendix provides detailed descriptions of certain configuration files
used by the Polycom® UC Software running on the Polycom VVX 1500 D
phone.
This appendix contains information on:
•
Master Configuration File
•
Configuration Parameters
The configuration parameters dictate the behavior of the phone once it is
running the executable specified in the master configuration file.
For detailed information—including permitted values, default values, and a
brief description—on the complete set of configuration parameters available
to you in the configuration files, refer to the "Configuration Files" appendix of
the latest Administrator's Guide for the Polycom UC Software.
You can also make changes to the configuration files through the web interface to
the phone. Using your chosen browser, enter the phone's IP address as the
browser address. For more information, refer to
Using the Web Interface
Changes made through the web interface are written to the override file . These
changes remain active until Settings > Advanced > Admin Settings > Reset to
defaults > Reset Web Configuration is performed.
As of UC software 3.3.0, you only need to configure the parameters that do not
match their "built-in" defaults.
Certain configuration settings in Polycom UC Software 3.3.0 release are not
backward compatible to the previous configuration files (sip.cfg and phone1.cfg).
Review all configuration files used to configure the VVX 1500 D phones for previous
software releases.
For more information, refer to "Technical Bulletin 56449: Polycom SoundPoint
IP/SoundStation IP/VVX Software Changes" and "Technical Bulletin 60519:
Simplified Configuration Enhancements in Polycom UC Software 3.3.0". Both
technical bulletins can be found at
http://www.polycom.com/usa/en/support/voice/soundpoint_ip/VoIP_Technical_Bulle
tins_pub.html .
(MAC-address.cfg or 000000000000.cfg)
Modifying Phone's Configuration
on page 2-8.
A
A - 1
Advertisement
Table of Contents
