Deleting Cutting Edges - Siemens SINUMERIK 840D sl Operating Manual

7.2.4

Deleting cutting edges

You can delete unnecessary edges of a tool from the tool list.
Proceed as follows
HMI sl Universal
Operating Manual, 11/2006, 6FC5398-6AP10-1BA0
4. Press the "Edges" softkey in the "Tool list".
5. Press the "New cuttgEdge" softkey.
A new data set is stored in the list.
The edge number is incremented by 1 and the offset data are
assigned the values of the edge on which the cursor is positioned.
6. Enter the offset data for the second cutting edge.
7. Repeat this process if you wish to create more tool edge offset data.
1. Select the "Parameter" operating area.
2. Press the "Tool list" softkey.
3. Place the cursor on the edge of a tool that you would like to delete.
4. Press the "Edges" softkey in the "Tool list".
5. Press the "Delete cut. edge" softkey.
The data set is deleted from the list.
Tool management
7.2 Tool list
113