Magazine - Siemens SINUMERIK 840D sl Operating Manual

7.5

Magazine

Tools are displayed with their magazine-related data in the magazine list. Here, you can take
specific actions relating to the magazines.
Individual magazine locations can be location-coded or disabled for existing tools.
Tool parameters
Column heading
Location
* If activated in magazine
selection
Type
Tool name
DP
D
G
Mag.loctype
Tool.loctype
L R
P
Magazine list icons
Icon /
Identification
Type
Red "X"
Yellow triangle
HMI sl Universal
Operating Manual, 11/2006, 6FC5398-6AP10-1BA0
*
*
Description
The tool is disabled.
The prewarning limit has been reached.
Description
Magazine location number
Spindle location as an icon
•
The locations for gripper 1 and gripper 2 (applies only when a spindle
•
with dual gripper is used) as icons.
The magazine location numbers
•
The magazine number is specified first, followed by the location
number.
If there is only one magazine, only the location number is displayed.
Tool type
Depending on the tool type (represented by a symbol), certain tool offset
data are enabled.
A tool is identified by its name and duplo number of the tool. You may
enter the names as text or numbers.
Duplo number of twin tool (replacement tool).
Cutting edge number
Disabling of the magazine location.
Display of magazine location type
Display of tool location type of tool.
Assignment of neighboring magazine locations. Defines the permissible
tool size.
Up to 7 neighboring half locations can be reserved for a tool.
Fixed location coding.
The tool is permanently assigned to this magazine location.
Tool management
7.5 Magazine
121