Tool List - Siemens SINUMERIK 840D sl Operating Manual

Tool management

7.2 Tool list

7.2 Tool list
The Tool list shows all tools in the magazines and the NC memory.
Each tool is uniquely identified by a name and a duplo number.
Tool parameters
Column heading
Location
* If activated in magazine
selection
Type
Tool name
DP
D
Length 1
Radius
Tip angle or
Lead
N
108
Description
Magazine/location number
•
*
•
*
•
Tool type
Specific tool offset data are displayed based on the tool type (represented
by a symbol).
A tool is identified by its name and duplo number of the tool. You may
enter the names as text or numbers.
Duplo number of twin tool (replacement tool)
Cutting edge number
Tool length
Geometry data length 1
Tool radius
Tip angle for Type 200 - twist drill and Type 220 - center drill
Lead for Type 240 - tap
Number of teeth for Type 110 - ball end mill for cylindrical die-sinking
cutter, Type 111 - ball end mill for tapered die-sinking cutter, Type 120 -
end mill, Type 121 - end mill with corner rounding, Type 130 - angle head
cutter, Type 140 - facing tool, Type 150 - side mill, Type 155 - bevel
cutter, Type 156 - bevel cutter with corner rounding, and Type 157 -
tapered die-sinking cutter.
Spindle location as an icon
The locations for gripper 1 and gripper 2 (applies only when a spindle
with dual gripper is used) as icons.
Magazine location number
The magazine number is specified first, followed by the location
number in the magazine.
If there is only one magazine, only the location number is displayed.
Operating Manual, 11/2006, 6FC5398-6AP10-1BA0
HMI sl Universal