Siemens SINUMERIK 840D sl Operating Manual page 41

Work offsets
G54 ...G599
Prog. ZO
Frame cycles
Entire ZO
The availability of the offsets depends on the setting.
Proceed as follows
Note
Further details on zero offsets
If you would like to see further details about the specified offsets or if you would like to
change values for the rotation, scaling or mirroring, press the "Details" softkey.
HMI sl Universal
Operating Manual, 11/2006, 6FC5398-6AP10-1BA0
Display of all zero offsets activated with G54 - G599, as well as
rotation, scaling and mirroring if these are set.
You cannot edit these values here.
Display of all additional zero offsets programmed with $P_PFRAME=.
as well as rotation, scaling and mirroring if these are set.
Display of all additional zero offsets activated via
$MC_MM_SYSTEM_FRAME_MASK.
Display of the active zero offset, representing the sum of all zero
offsets, as well as rotation, scaling and mirroring if these are set.
Machine manufacturer
Please also refer to the machine manufacturer's instructions.
1. Select the "Parameter" operating area.
2. Press the "Work offset" softkey.
The "Work offset - Active" window is opened.
Setting up the machine
2.5 Work offsets
41