9.02 Entering Charge Management Mode
Operation
1. Set the MEMORY switch at
the rear of PITS to
"PROGRAM."
2. Enter "04."
3. Enter the Charge Management
ID Code: four digits.
Result
•
PITS-PGM No.?
• The MEMORY indicator lights
in red.
•
ID Code?
•
ID Code?
1234
• Charge Management
Initial Display
Charge Meter
12-C-34
(70695)
Comment/Note
• This display is called "Initial
display for PITS station
programming mode."
• If the following message
appears on the display, the
programming data of your
PITS has already been
accessed by another
administration device.
Already Accessed
• From now on, in any status,
pressing the END button
restores this status.
• Default – 1234
Refer to Section 11-C-10.00
"Setting Charge Management
ID Code" for further
information.
• If the ID code entered is not
correct, you hear alarm tone.
• This display is called "Initial
display for Charge
Management mode."