Changing Configuration Settings; Changing The Configuration Settings From The Display - Intermec PB50 User Manual

Changing Configuration Settings

PB50 Portable Label Printer User's Guide
Options in Extended Test Mode
Function
Select Media
Test Labels
Dump Mode
Factory Default
Setup and Exit
Exit
There are several ways you can change the configuration settings
of the printer. You can change the configuration settings:
• from the display.
• from the host PC using PrintSet.
• from the host PC using the command line.
• from the printer home page.
• from the SmartSystems Console.

Changing the Configuration Settings From the Display

You need to enter Setup mode before you can change
configuration settings. For more information on entering Setup
mode and navigating through the settings, see
Setup Mode" on page
Chapter 2 — Configuring the PB50
Description
This option is almost the same as the process
in Test mode, except that the printer performs
a slow test feed in Extended Test mode. The
slow test feed enables the printer to perform a
slow sensor calibration which can help resolve
gap or mark detection problems.
This option allows you to print test labels one
at a time. Press to print the next label.
This options enters Dump mode. For more
on Dump mode, see
information
"Troubleshooting Communication
Problems" on page 42
This option restores the factory default
settings. Press to select this option and
then follow the instructions on the screen.
This option exits Extended Test mode and
puts the printer in Setup mode.
This option exits Extended Test mode.
17.
.
"Understanding
21