Intermec PB50 User Manual page 40

Chapter 2 — Configuring the PB50
32
setup "wlan","ACTIVE","1"
setup write "wlan","uart1:"
Where xxxxxxxxxx is a value between 8 and 64 characters.
To configure the PB50 to use WPA or WPA2 Enterprise mode
1 Send the following commands to login as an admin and set
the SSID:
run"su-p pass admin"
setup write "wlan","uart1:"
setup "wlan","SSID","xxxxx"
Where xxxxx can be from 0 to 32 alphanumeric characters.
2 Send the following commands to set up WPA-802.1x or
WPA2-802.1x authentication:
setup "wlan","WPA","ON"
setup "wlan","WPA2","ON"
setup "wlan","WPA_PSK",""
setup write "wlan","uart1:"
• To view the 802.1x values, send this command:
setup write "8021x","uart1:"
3 Send these commands to configure the EAP_TYPE:
setup "8021x","EAP_TYPE","xxxx"
Where xxxx can be OFF, LEAP, PEAP, or TTLS.
setup "8021x",".EAP_USER","xxxx"
setup "8021x","EAP_PASS","xxxx"
Where xxxx can be an alphanumeric value up to ?? characters.
4 If you are using TTLS, you may need to send this command
to set the TTLS outer name:
setup "8021x","TTLS_USER","xxxx"
Where xxxx can be an alphanumeric value up to
5 If you are using certificates for validation, here are some
commands you may need to use.
• Send the following commands to set a certificate and
enable validation:
setup "8021x","CA_CERT","c:/test.pfx@export"
setup "8021x","VALIDATE","ON"
PB50 Portable Label Printer User's Guide
??? characters.