About Printer Configuration; Changing The Basic Configuration Settings - Intermec 4400 User Manual

This chapter explains how to set the configuration parameters for optimizing label
quality, printer performance and print speed, emulating an 8636/46 printer, and
customizing your printer for media type, media alert, and character set. It also
explains how to restore the factory default configuration.

About Printer Configuration

When you configure your printer, you customize it to meet your distinct
operational needs, which include optimizing the print quality and print speed
of your labels. The printer is shipped with default configuration settings that
work in most operating environments, but are easily changed if necessary. The
4400 printer has a large variety of configuration settings as shown on the
foldout page in the previous chapter. Use this circle to familiarize yourself with
all the options available under the Configuration menu.

Changing the Basic Configuration Settings

The following table shows all the configuration settings available under Basic
in the Configuration menu, except the Printhead Range setting. (For
information on this setting, see "Adjusting the Printhead Range" later in this
chapter.) Commands to enable options (Self-Strip or Cutter) are marked with
an asterisk (*) since they appear on the menu only after being installed. Default
values are shown in bold.
Note: For some commands you must cycle the power (turn the printer off and then on
again) or press [FEED/RELOAD] after changing the setting. Cycling the power puts
all changes into effect at once.
NugFont
HelvC
C o d e 3 9
Configuring the Printer
5
5-3