Charging The Batteries - Intermec PB50 User Manual

Charging the Batteries

PB50 Portable Label Printer User's Guide
Chapter 1 — Using the PB50 Portable Label Printer
2 Insert the battery with the tab facing away from the front
control panel.
3 Insert the edge of the battery under the lip of the PB50 and
then push down until you hear the battery latch click.
There are two ways to charge the PB50 battery:
• connect AC power to the printer and charge the battery while
it is in the PB50.
• Charge the battery in the AC18 4-bay battery charger.
For information on charging your battery in the 4-bay battery
charger, see the AC18 4-Bay Battery Charger Instructions
(P/N 943-128-001).
It takes approximately 4 hours to charge the battery while it is
installed in the PB50 printer. To charge the battery inside the
PB50, you need:
• an Intermec 12 VDC power supply (Model AE19).
7