Intermec PB50 User Manual page 20

Chapter 1 — Using the PB50 Portable Label Printer
12
To load media for self-strip printing
1 Complete Steps 1 through 4 in the previous procedure.
2 Open the self-strip door in the media cover.
Self-strip
door
3 Remove a label from the roll of media so that you are left with
several inches of label liner.
4 Feed the label liner over the self-strip bar and out the back of
the self-strip door.
5 Close the media cover until it latches and press down on the
self-strip door to make sure it locks.
Self-strip
bar
PB50 Portable Label Printer User's Guide