Screw-Mounting The Adapter; Using The Stand Adapter - VeriFone PINpad 1000SE CTLS Installation Manual

S
ETUP

Using the Stand Adapter

Screw-Mounting the
Adapter
Using the Stand
Adapter
18
PIN 1000 CTLS I
PAD SE
Figure 9 Stand Adapter Installation
The stand adapter may also be screwed directly to a wall or countertop.
•
Use screw anchors when fastening the adapter to a cement or brick wall.
•
When fastening the plate to drywall, the screws must go into the studs behind
the wall. Screw anchors alone will not safely hold the adapter to drywall.
To screw-mount the stand adaptor to the PINpad 1000
National Standard #8 or Metric M3 screws 8 mm length, with head diameter
between 4.5 and 6.0 mm, and head thickness less than 2.5 mm. Use the stand
adaptor to mark the hole placement on the desired location, and then insert
screws, adjusting the screw depth until the unit is firmly mounted.
Figure 10 shows how to insert a PINpad 1000
the end of the PINpad 1000
press the screen end of the PINpad 1000
adapter until you hear and feel the release lever click.
Figure 10 Inserting the PINpad 1000
To remove the adapter, press the release lever at the top of the stand and pull the
PINpad 1000 CTLS up and out of the stand adapter.
SE
G
NSTALLATION UIDE
CTLS into a stand adapter. Slide
SE
CTLS into the bottom of the stand adapter, then
SE
CTLS firmly into the top of the stand
SE
CTLS into the Stand Adapter
SE
CTLS, use American
SE