Stylus And Holder; Mounting Plate - VeriFone P200 Installation Manual

Stylus and Holder

Attaching the Stylus
Holder

Mounting Plate

Attaching a Mounting
Plate to P200
Mounting P200 with
Mounting Plate to a
Wall or Flat Surface
Mounting P200 to a
Flat Surface (Without
a Mounting Plate)
NOTE
Mounting P200 with
Mounting Plate to a
Vertical Bracket
A stylus with holder can be attached to P200 and used as an alternative device
input method.
To attach the stylus:
Align the stylus holder's screw holes with those found on the back of
1
the terminal.
Screw the holder onto the back of the terminal.
2
This accessory is used to mount P200 to vertical or inclined surfaces.
To attach a mounting plate to P200:
Align the screw holes at the back of the terminal with the corresponding
1
screws on the mounting plate (this can be done with or without the stylus
holder attached).
Screw the mounting plate in place, keeping the terminal aligned.
2
To mount the terminal to a wall or flat surface:
Ensure the mounting plate is attached to the terminal.
1
Attach three M3 screws (not included in P200 package) to the desired surface.
2
Make sure that they are aligned with the slots on top and at the bottom of the
mounting plate.
Secure the terminal with the mounting plate in place by aligning the holes to
3
the M3 screws then sliding the entire assembly into place.
Slide the terminal down to secure it to the mounting plate. To remove the
4
terminal, slide the terminal up and pull away from the mounting plate.
To mount the terminal to a flat surface:
Align the terminal's footers to the holes on the mounting plate.
1
Fit the footers of the terminal into the footer holes.
2
Screw the mounting plate in place.
3
Customized plates must have four recessed areas big enough to fit the footers of
the terminal. This ensures that there is no gap between the terminal and
mounting plate.
To mount the terminal with a mounting plate to a vertical bracket:
Ensure the mounting plate is attached to the terminal.
1
Align the three screw holes of the mounting plate with the vertical bracket
2
holes.
Screw the vertical bracket in place.
3
Optional Accessories
P200/P200 P I
LUS NSTALLATION
S
ETUP
G
UIDE 25