Connecting Via Usb; Contactless Support; Selecting Contactless Device Modes - VeriFone PINpad 1000SE CTLS Installation Manual

S
ETUP

Connecting via USB

Connecting via
USB
CAUTION
NOTE
Contactless
Support
Selecting
Contactless Device
Modes
NOTE
14
PIN 1000 CTLS I
PAD SE
The USB version of the PINpad 1000
terminal, ECR, or a host PC using a coiled USB cable (VPN#WCL115013-A).
When connecting to a PC via a USB port, the device, in either PINpad 1000
CTLS PCI mode or NURIT 222 mode – requires the additional installation of
device drivers.
1
Connect the device to the host PC.
2
Connect the cable to external power supply.
3
Wait until the host PC recognizes the new hardware and starts the Found New
Hardware Wizard.
4
Follow the instructions on the Found New Hardware Wizard to install the USB-
UART driver.
If an extension cable is required when connecting by the device's USB port, only
USB-certified cables should be used.
Additional instructions and device drivers are found and downloaded from the
VeriFone Technical Support page:
(http://www.verifone.com/technical-support.aspx).
Browse to the INF file provided by VeriFone when specifying the driver location.
When the installation is done, check the list of ports on the Device Manager to see
the new USB device.
The PINpad 1000
SE
from American Express, MasterCard, Visa, and Discover with virtually no changes
to existing payment hardware or software.
To allow a PINpad 1000
device mode should be set to Contactless. By default, operating mode of all
PINpad 1000 CTLS devices, including the PINpad 1000
SE
PINpad.
Users can switch from PINpad mode to Contactless mode thru menu options
shown at the terminal's interface.
For more information on switching Device Modes, refer to PINpad 1000
Reference and Programmers Guide, VPN - 26803. Device mode refers to the
device's current operating mode, either PINpad or Contactless.
G
NSTALLATION UIDE
CTLS can also be connected to a
SE
CTLS supports the global contactless program specifications
CTLS device to process contactless transactions, its
SE
SE
CTLS, is set to
SE
SE