Connecting Unit To Controller - VeriFone PINpad 1000SE CTLS Installation Manual

S
ETUP

Connecting Unit to Controller

Connecting Unit
to Controller
WARNING
NOTE
12
PIN 1000 CTLS I
PAD SE
The PINpad 1000
SE
power and communication connection to the controller. The connection methods
differ between two specific versions of the PINpad 1000
232. This section discusses a connection to the RS-232 version of the
PINpad 1000 CTLS.
SE
Turn off or unplug the controller when connecting or disconnecting the
PINpad 1000 CTLS. Memory corruption and data loss can result if the controller
SE
is processing data when power is removed.
Refer to the controller device instructions for any controller-specific warnings.
Figure 3 illustrates how to connect the PINpad 1000
series terminal. For other terminal or controller connections, refer to the reference
manual for that controller.
Figure 3 PINpad 1000
1
Disconnect power from the terminal or ECR.
2
Position the PINpad 1000
avoid damaging the keypad or display.
3
Connect the modular plug on the cable to the modular jack on the rear of the
PINpad 1000
SE
4
Connect the other end of the cable to the PlN pad port on the rear of the
terminal.
5
Reconnect power to the terminal.
For cable removal, use the same steps described above in reverse. If exchanging
cables, use a VeriFone-approved cable. For more information, refer to
PINpad 1000 CTLS Quick Installation Guide, VPN - DOC115EN05-A.
SE
G
NSTALLATION UIDE
CTLS rear panel has a modular, four-wire interface port for
CTLS and Terminal Cable Connections
SE
CTLS face down on a soft, smooth surface to
SE
CTLS device.
CTLS – USB and RS-
SE
CTLS to a Omni 37xx
SE