Processing Contactless Transactions; Using The Stand Adapter; Mounting The Adapter To Plate - VeriFone PINpad 1000SE CTLS Installation Manual

Processing
Contactless
Transactions
Using the Stand
Adapter
Mounting the
Adapter to Plate
The PINpad 1000 CTLS is only active when signaled by an application for the
SE
conduction of a contactless smart card transaction.
To perform a contactless smart card transaction:
1
Gently tap the card onto or hold the card (within to 4 cm) against the surface of
the RFID antenna.
2
A short beeping sound and the lighting of four LEDs indicates a successful
transaction.
Figure 8 PINpad 1000
The optional stand adapter holds the PINpad 1000
countertop or a wall. The unit can be removed from the stand adapter for
handheld operation.
Figure 9 shows how to install a stand adapter onto a pre-existing flat mounting
plate.
1
Select a location for the stand adapter on a smooth wall or countertop. Be sure
the cable can easily reach the controller from this position without stretching.
2
Position the keyholes on the molded cradle over the slotted screws on
mounting plate. Slide the adapter downward until the screws are in the narrow
ends of the keyholes.
CTLS with Smart Card
SE
SE
PIN
PAD

Using the Stand Adapter

CTLS securely to a
1000 CTLS I
SE NSTALLATION
S
ETUP
17
G
UIDE