Mounting P400 To A Flat Surface (Without A Mounting Adapter); Mounting P400 With Mounting Adapter To A Vertical Bracket - VeriFone P400 Installation Manual

Mounting P400 to a
Flat Surface
(Without a Mounting
Adapter)
NOTE
Mounting P400 with
Mounting Adapter to
a Vertical Bracket
CAUTION
3
Secure the terminal with the mounting adapter in place by aligning the holes to
the M3 screws then sliding the entire assembly into place.
4
Slide the terminal down to secure it to the mounting plate. To remove the
terminal, slide the terminal up and pull away from the mounting plate.
To mount the terminal to a flat surface:
1
Align the terminal's footers to the holes on the mounting plate.
2
Fit the footers of the terminal into the footer holes.
3
Screw the mounting plate in place.
Customized plates must have four recessed areas big enough to fit the footers of
the terminal. This ensures that there is no gap between the terminal and
mounting plate.
To mount the terminal with a mounting adapter to a vertical bracket:
1
Ensure the mounting adapter is attached to the terminal.
2
Align the three screw holes of the mounting adapter with the vertical bracket
holes.
3
Screw the vertical bracket in place.
Mounting Considerations
Avoid having metallic objects in proximity to the contactless antenna. If you need
to mount the terminal to vertical or inclined surfaces, use a flat mounting plate.
An enclosed metal frame or mount may negatively affect CTLS performance.
Optional Accessories
P400/P400 PLUS I
NSTALLATION
S
ETUP
19
G
UIDE