•
Do not allow any liquid to run down the surface of the touchscreen and under the bezel.
•
If using a damp cloth, disconnect power to the phone before wiping the screen.
CAUTION: Use of any type of cleaners, alcohol, ammonia, and/or hard or sharp objects can harm
the touchscreen surface and potentially cause transparent conductive film cracks in the screen.
To clean your Mitel 6940 IP phone's touchscreen:
1. Disconnect power to your phone.
2. Retrieve a soft cloth, such as a microfiber cloth.
3. If necessary, dampen the cloth. For regular cleanings, a dry cloth is usually sufficient. For
stubborn build-up or for periodic deep cleanings, wet the cloth under a faucet and then wring
out until it is just damp.
4. Wipe the screen gently with the cloth making sure to not get any moisture in the sides of the
screen. You can also wipe down the entire phone to remove dirt and grime.
5. Allow your phone to completely dry after you are done cleaning. This should only take a few
minutes.
6. Reconnect power to your phone.
Note: Keeping your touchscreen clean and free of dirt and fingerprints on a regular basis extends
the life of your phone's touchscreen.
Tips for your comfort and safety
Don't cradle the handset
Prolonged use of the handset can lead to neck, shoulder, or back discomfort, especially if you cradle
the handset between your ear and shoulder. If you use your phone a lot, you may find it more
comfortable to use a headset.
Protect your hearing
Your Mitel 6940 SIP IP phone has a control for adjusting the volume of the handset, headset, and
speakerphone. Because continuous exposure to loud sounds can contribute to hearing loss, keep
the volume at a moderate level.
Adjust the viewing angle
The stand for your Mitel 6940 SIP IP phone supports two viewing angles (30° and 60°). Adjust the
stand to suit your viewing preference. For instructions on how to adjust the stand, see the Mitel 6940
IP Phone Installation Guide.
Welcome
xiii