ZyXEL Communications NWA1123-ACv2 User Manual page 28

The following table describes the LEDs.
Table 9 NWA1123-AC PRO and WAC6103D-I LEDs
LED COLOR
PWR/SYS Red
Green
Red
Green
Red
Green
Red
Green
Red
Green
Red
Green
Management Green
WLAN Green
Amber
WLAN Green
Amber
UPLINK Amber/
Green
LAN Amber/
Green
Chapter 1 Introduction
STATUS DESCRIPTION
Slow Blinking (On for 1s, The NWA/WAC is booting up.
Off for 1s)
On
Off The NWA/WAC is ready for use.
On
On There is system error and the NWA/WAC cannot boot up,
or the NWA/WAC suffered a system failure.
Off
Fast Blinking (on for The NWA/WAC is doing firmware upgrade.
50ms, Off for 50ms)
Off
Slow Blinking (blink for 3 The Uplink port is disconnected.
times, Off for 3s)
Off
Slow Blinking (blink for 2 The wireless module of the NWA/WAC is disabled or
times, Off for 3s) failed.
Off
On The NWA/WAC is managed by a controller.
Slow Blinking (blink for 3 The NWA/WAC is searching (discovery) for a controller.
times, Off for 3s)
Off The NWA/WAC is in standalone mode.
On The antenna switch is set to "Ceiling" for the radio.
The 2.4 GHz WLAN is active.
On The antenna switch is set to "Wall" for the radio.
The 2.4 GHz WLAN is active.
Off The 2.4 GHz WLAN is not active.
On The antenna switch is set to "Ceiling" for the radio.
The 5 GHz WLAN is active.
On The antenna switch is set to "Wall" for the radio.
The 5 GHz WLAN is active.
Off The 5 GHz WLAN is not active.
On Amber - The port is operating as a 100-Mbps connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
Blinking The NWA/WAC is sending/receiving data through the
port.
Off The port is not connected.
On Amber - The port is operating as a 100-Mbps connection.
Green - The port is operating as a Gigabit connection
(1000 Mbps).
Blinking The LAN port is sending/receiving data through the port.
Off The LAN port is not connected.
NWA / WAC Series User's Guide
28