ZyXEL Communications NWA1123-ACv2 User Manual page 183

Figure 116 Active Log Summary
This screen provides a different view and a different way of indicating which messages are included in
each log and each alert. (The Default category includes debugging messages generated by open
source software.)
The following table describes the fields in this screen.
Table 84 Configuration > Log & Report > Log Setting > Active Log Summary
LABEL DESCRIPTION
Active Log If the NWA/WAC is set to controller mode, the AC section controls logs generated by the
Summary controller and the AP section controls logs generated by the managed APs.
System log Use the System Log drop-down list to change the log settings for all of the log categories.
disable all logs (red X) - do not log any information for any category for the system log or e-mail
any logs to e-mail server 1 or 2.
enable normal logs (green check mark) - create log messages and alerts for all categories for
the system log. If e-mail server 1 or 2 also has normal logs enabled, the NWA/WAC will e-mail
logs to them.
enable normal logs and debug logs (yellow check mark) - create log messages, alerts, and
debugging information for all categories. The NWA/WAC does not e-mail debugging
information, even if this setting is selected.
Chapter 15 Log and Report
NWA / WAC Series User's Guide
183