Functions During The Measurement In The Cycling Mode; Start The Cycling Measurement; Swap The Wheel Size - Polar Electro Polar Protrainer XT User Manual

FUNCTIONS DURING THE
MEASUREMENT IN THE
CYCLING MODE

1. START THE CYCLING MEASUREMENT

1. Wear the Transmitter as described in Getting going.
2. Attach the Polar Protrainer XT receiver on the Polar Bike Mount.
3. Install the Polar Speed Sensor on the front fork of your bike as
instructed in the Polar Speed Sensor manual.
4. Check that there are no disturbances near you as you are about to start
the code search for coded transmission.
Make sure that the code search will be successful:
• Keep the bike still. Do not ride or move your bike before
the code has been picked up.
• Keep the receiver within 3 feet/1 metre from your Polar
Coded Transmitter.
• Check that you are not near to other people with heart rate
monitors, high voltage power lines, televisions, mobile phones,
cars, exercise equipment etc.
5. There are two different ways to start the cycling measurement. Check
whether you have the cycling symbol in the Time of day display or not
and, according to that, start the code search and heart rate
measurement as follows:
There is no bike symbol
day display if your most recent exercise
was done in the Heart rate mode.
1. Press SET/START/STOP and
SIGNAL/LIGHT simultaneously in
the Time of day display to start
the Cycling measurement.
32
PROXT GBR/E
in the time of
32-33
There is a bike symbol in the time of day
display if your most recent exercise was done
in the Cycling mode.
1. Press SELECT to start the Cycling mode.
The receiver starts searching for coded
transmission for max. 20 seconds.
The coded heart rate information appears
in the bottom line of the display.
If the code search was not successful, 00
appears in the display. Restart the measurement
from the Time of day display and follow the above
mentioned precautions during the code search.

Swap the wheel size

If you have two bikes with different wheel sizes you should set
values for both the WHL 1 and WHL 2.
Calibrating the wheel size.
Swap the wheel size according to your bike as follows:
1. Start the cycling measurement but don't start the stopwatch yet.
2. Press and hold the SELECT button until the WHL 1 / WHL 2 is
displayed for a few seconds.
Display will return to the cycling measurement mode.
6. Start the stopwatch by pressing SET/START/STOP.
Stopwatch starts running and you hear a long beep.
Display is illuminated for a few seconds.
7. You can now start your cycling exercise.
Your safety is important to us. While riding your bike, please keep
your eyes on the road to prevent possible accidents and injury.
Display in the Cycling mode
• cycling info loop
Cycling info loop includes: trip, stopwatch,
time of day, average speed, maximum
speed and lap number. Select the cycling
info display by pressing SIGNAL/LIGHT.
• Target Zone indication
• speed
• cycling mode indicator
• heart rate
7.2.2001, 09:01
33