Password Settings; Ide Hdd Auto Detection Option - ECS P6SEP-Me User Manual

USB Keyboard Support
Enable this item if you are using a keyboard connected through the USB interface.
Init Display First
Use this item to define if your graphics adapter is installed in one of the PCI slots.
Current CPU Temperature, Current CPUFAN1 Speed, etc.
If you are using the hardware monitoring features of this system, you can use these
items to set thermal parameters for the system.

Password Settings

This item can be used to install a password. To install a password, follow these steps:
1. Highlight the item Password Settings on the main menu and press Enter.
2. The password dialog box will appear.
3. If you are installing a new password, carefully type in the password. You cannot
use more than 8 characters or numbers. The password will differentiate between
upper case and lower characters. Press Enter after you have typed in the
password. If you are deleting a password that is already installed just press Enter
when the password dialog box appears.
4. The system will ask you to confirm the new password by asking you to type it in a
second time. Carefully type the password again and press Enter, or just press
Enter if you are deleting a password that is already installed.
5. If you typed the password correctly, the password will be installed.

IDE HDD Auto Detection Option

This item automatically detects and installs any hard disk drives installed on the
primary and secondary IDE channel. Most modern drives can be detected. If you are
using a very old drive that can't be detected, you can install it manually using the
Standard CMOS Setup option.
Setup will check for two devices on the primary IDE channel and then two devices on
the secondary IDE channel. At each device, the system will flash an N in the dialog
box. Press Enter to skip the device and proceed to the next device. Press Y, then
Enter to tell the system to auto-detect the device.
36
Default: Disabled
Default: PCI Slot