ECS P6SEP-Me User Manual page 37

Power Button Over Ride
Under ACPI (advanced configuration and power interface) the system can be turned
off mechanically (by the power button) or it can undergo a software power off. If the
system has been turned off by software, the system can be resumed by a LAN,
MODEM or ALARM wake up signal. This item allows you to define a software
power off using the power button. If the value is set to Instant-Off, the power button
will automatically cause a software power off. If the value is set to Delay 4 Sec. the
power button must be held down for a full four seconds to cause a software power off.
LAN /ring Wake Up
If this item is enabled, it allows the system to resume from a software powerdown
whenever there is incoming traffic or call to an installed network adapter or external
Modem. For this feature to operate, the network adapter card must be connected to the
Wake On LAN connector on the mainboard.
Modem Wake Up
If this item is enabled, it allows the system to resume from a software powerdown
whenever there is an incoming call to an internal fax/modem card. For this feature to
operate, the fax/modem card must be connected to the Wake On Modem connector on
the mainboard.
PME# Wake Up
If this item is enabled, it allows the system to resume from a software powerdown
whenever there is incoming traffic to an installed network adapte. For this feature to
operate, the network adapter card must support PCI 2.2 specification.
AC Resume
If this item is enabled, it allows the system to resume operation automatically
whenever the system is halted by an unexpected interruption in the supply of AC
power (for example a power blackout).
KB Power ON Password
You can use this item to install a password that you can type on the system keyboard
in order to start the system.
Power Up By Alarm
If this item is Enabled, it allows you to set a date and time alarm that will
automatically resume the system from a software power down. When you enable this
feature, new setup items appear to let you set the alarm. Month Alarm lets you select a
month from 1 to 12. Day of the Month Alarm lets you select a day from 1 to 31. Week
Alarm lets you select a recurring alarm for any day of the week. Time Alarm lets you
select a time for the alarm in hours, minutes, and seconds.
Default: Instant Off
Default: Enabled
Default: Enabled
Default:Disabled
Default: Disabled
Default: Enter
Default: Disabled
31