ECS P6SEP-Me User Manual page 36

HDD Off After
If you have selected User Define for the Power Management item, you can set this
item to a selection of timeouts from 1 to 15 minutes. The hard disk drive will power
down if the selected timeout passes without any activity on the hard disk.
Doze Mode
If you have selected User Define for the Power Management item, you can set this
item to a selection of timeouts from 10 seconds to 4 hours. The system will go into the
power-saving doze mode if the selected timeout passes without any system activity.
Standby Mode
If you have selected User Define for the Power Management item, you can set this
item to a selection of timeouts from 10 seconds to 4 hours. The system will go into the
power-saving standby mode if the selected timeout passes without any system activity.
Suspend Mode
If you have selected User Define for the Power Management item, you can set this
item to a selection of timeouts from 10 seconds to 4 hours. The system will go into the
power-saving suspend mode if the selected timeout passes without any system activity.
HDD Ports Activity
When this item is Enabled, any activity on the hard disk drive will automatically reset
the timeout counters for the power-saving modes, or resume the system from a power-
saving mode.
COM Ports Activity
When this item is Enabled, any activity through the serial ports (COM1/3, COM2/4, or
an Infrared Port) will automatically reset the timeout counters for the power-saving
modes, or resume the system from a power-saving mode.
LPT Ports Activity
When this item is Enabled, any activity through the parallel port (LPT1) will
automatically reset the timeout counters for the power-saving modes, or resume the
system from a power-saving mode.
VGA Activity
When this item is Enabled, any activity on the graphics sub-system will automatically
reset the timeout counters for the power-saving modes, or resume the system from a
power-saving mode.
IRQ[3-7, 9-15],NMI
When this item is Enabled, if any activity is detected on the system interrupts (IRQs)
and the non-masked interrupt (NMI), the system will automatically reset the timeout
counters for the power-saving modes, or resume the system from a power-saving
mode.
IRQ 8 Break Suspend
When this item is enabled, any activity through the system interrupt request line 8 can
reset power-saving mode timeouts to zero, or resume the system from a power saving
mode. IRQ 8 is normally used by the system realtime clock.
30
Default: Disabled
Default: Disabled
Default: Disabled
Default: Disabled
Default: Enabled
Default: Enabled
Default: Enabled
Default: Disabled
Default: Enabled
Default: Disabled