Supervisor And User Password Settings; Ide Hdd Auto Detection Option - ECS P6BAT-B Manual

Parallel Port Mode
This item defines the operation of the parallel port. It can be set to SPP (standard
parallel port). If you are connected to a parallel device that supports the higher-
performance EPP (enhanced parallel port) or the ECP (extended capabilities port)
make the appropriate changes to this item.
OnChip USB
Use this item to enable or disable the USB ports that are integrated in this
mainboard.
USB Keyboard Support:
Enable this item if you plan on using a keyboard that operates through a USB
port.

Supervisor and User Password Settings

This item can be used to install a password. To install a password, follow
these steps:
1. Highlight the item Password Settings on the main menu and press
Enter.
2. The password dialog box appears.
3. If you are installing a new password, carefully type in the password.
You cannot use more than 8 characters or numbers. The password
will differentiate between upper case and lower characters. Press
Enter after you have typed in the password. If you are deleting a
password that is already installed just press Enter when the
password dialog box appears.
4. The system will ask you to confirm the new password by asking you
to type it in a second time. Carefully type the password again and
press Enter, or just press Enter if you are deleting a password that
is already installed.
5. If you typed the password correctly, the password will be installed.

IDE HDD Auto Detection Option

This item automatically detects and installs any hard disk drives installed
on the primary and secondary IDE channel. Most modern drives can be
detected. If you are using a very old drive that can't be detected, you can
install it manually using the Standard CMOS Setup option.
Setup will check for two devices on the primary IDE channel and then
two devices on the secondary IDE channel. At each device, the system
Default: SPP
Default: Enabled
Default: Disabled
57