Table of Contents
Advertisement
JP3: Flash BIOS Enable/Disable Jumper
The BIOS on this mainboard is stored on an Erasable Programmable Read Only Memory
(EPROM) chip. This means that you can erase the current BIOS and install an updated
BIOS whenever new upgrades are released. See Chapter 4 for information on using the
Flash BIOS utility. Before erasing the old BIOS and flashing a new BIOS, you must set
JP3 to Enable. After the new BIOS is installed, set JP3 to Disable so that the BIOS
cannot be erased by accident.
Function
Enable Flash BIOS
Disable Flash BIOS
JP7: Fax/modem Extension Bracket
The fax/modem extension bracket is supplied with this mainboard.
1. Locate the JP7 fax/modem connector on the mainboard.
2. Remove the expansion slot blanking plate from the system chassis that is adjacent to
the fax/modem connector.
3. Install the fax/modem extension bracket on to the MDM1 connector as shown below.
The RJ11 Line and Telephone sockets on the bracket are positioned in the expansion
slot with the removed blanking plate.
Line and Tel
RJ11 sockets
JP7
fax/modem
connector
JP3
Jumper Cap
Short Pins 1-2
1 2 3
Short pins 2-3
1
Fax/modem
extension bracket
1
1
1
13
Advertisement
Table of Contents
