Planet Networking & Communication ADE-4400v3 User Manual page 58

IPSec Settings of ADW-4401 Site B:
Step 1. Enable the VPN, it needs to take several minutes.
Step 2. Enter a Name for this connection.
Step 3. Enter the Local public IP as "61.62.236.12".
Step 4. Enter the Remote public IP as "203.73.50.242". (ADW-4401-A WAN IP)
Step 5. Enter the Local private IP as "192.168.10.0/24".
Step 6. Enter the Remote private IP as "192.168.1.0/24". (Site A Subnet)
Step 7. Enter the PSK Key as "123456789", it must match with ADW-4401-A.
Step 8. Click "Add" to add this VPN connection.
Step 9. Click "connect" to establish the IPSec VPN tunnel with remote site.
You will see the successfully message if the settings of two sites are properly.
And now status of the IPSec connection is up! The clients on Site A and Site B can access
the resource by each other.
Note:
The IPSec / PPTP features are only for ADW-4401v4 with firmware v1.3.9.14.
Please upgrade your ADW-4401v4 to v1.3.9.14 first; you can download this
firmware on Planet Web site.
When you reboot the device, the IPSec function will disable. Please enable it
again and re-connect the VPN connection by above steps.
58