Planet Networking & Communication ADE-4400v3 User Manual page 12

defaults, keep the device powered on and push a paper clip into the hole.
Press down the button over 5 seconds and then release.
Power Power connector with 12V DC 1.0 A
Router is successfully connected to a device through the corresponding port
Ethernet
(1, 2, 3, or 4). If the LED is flashing, the Router is actively sending or receiving
1-4
data over that port.
The RJ-11 connector allows data communication between the modem and the
Line
ADSL network through a twisted-pair phone wire.
12