Planet Networking & Communication ADE-4400v3 User Manual page 10

Front Panel LED definition
LED State
ON
PWR Red
OFF
ON
Link
Flashing
Data Flashing
ON
LAN
Flashing
Rear Panel
Rear Panel Port and Button Definition
Connector
POWER The power button is for turn on or turns off the router.
Button
Power connector with 10V DC 1.0 A
Power
The reset button can restore the default settings of device. To restore factory
Reset defaults, keep the device powered on and push a paper clip into the hole.
Press down the button over 5 seconds and then release.
Router is successfully connected to a device through the Ethernet port. If the
Ethernet
LED is flashing, the Router is actively sending or receiving data over that port.
The RJ-11 connector allows data communication between the modem and the
Line
ADSL network through a twisted-pair phone wire.
When the router is powered on and in ready state.
The devise is being turned on and booting.
When the router is powered off.
Successful connection between ADSL modem and telecom's
network.
Modem is trying to establish a connection to telecom's network.
Data is transferred between Router and Internet.
Link
TX or RX activity.
Description
10
Description